Novidades

NEW THICKNESS METER IS IN USE IN CARDBOARD 21/01/2015

NEW THICKNESS METER IS IN USE IN CARDBOARD
In order to avoid the release material outside the specified thickness, Cardboard Timbo invested in 2014 in new equipment Thickness Gauge.
We started the day 01/12/14 the use of new equipment, which is automated and was attached to the calender, where the measurement is made soon after the calendering process.
The thickness meter is programmed with the thickness tolerances of the product being processed.
Example: Nominal thickness 2,00mm. Minimum and maximum 1,90mm 2,10mm. So the meter is programmed to consider 1,90mm to 2,10mm.
This setting can only be made by an authorized person, and operators do not have access to change it.
The Thickness Gauge has three identification lights. A red to identify products with thicknesses greater than the allowed tolerance. The second red to identify products with thickness less than the permitted tolerance. Finally a third green to identify the products within the tolerance, so approved.
This greatly facilitates the work of the operator, because the non-compliant products can be separated into cells identified as \'below\' or \'above\' tolerance for appropriate destination.
The materials are then measured after leaving the calender, which are also separated.
The same operator can receive calendered material, measure with this new device and separate the cells. We gain credibility in measurement and productivity in the operation.

  Street Marechal Floriano Peixoto, 121 - Center
Timbó - SC / 89120-000
© Copyright 2018 Fábrica de Papelão Timbó LTDA.
All rights reserved
Xthor Soluções Tecnológicas

(47) 3281-4500